MDF - Interior Panels
CE

Google translate

English Danish Estonian French German Polish Russian Spanish Swedish

MDF - Interior Panels

Read the instructions carefully before the installation of the interior panels!

BEFORE INSTALLATION
Note that the interior panels are meant only for indoor use and they must not be in direct contact with moisture. Interior panels are not suitable to be installed to the ceiling.
Any faults in the materials shall be reported to prior to the installation. Large surfaces should be made of the same production batch.
The batch number can be found on the bottom interior panel of the package. The interior panel suits only for premises where the room temperature and humidity are normal, approx. 20°C, and the relative humidity is approx. 40%, i.e. the walls and the ceiling of the room shall be dry with window glasses.
Interior panels should not be exposed to continuous temperatures of over 70°C. Please note the lighting manufacturer’s installation instructions concerning the temperature. The temperature and humidity of the interior panels shall be let to stabilise to the same temperature and humidity with the installation environment for three days before the installation. There is no need to open the packages completely, it is enough that you make a hole to the ends of the packages from where the humidity can be removed.

INSTALLATION
The interior panels can be attached directly to the old surface. Make sure the sufficient fastening of the bottom surface. The product is oversized, which allows a small tear in the film surface and skew (2 cm) within the dimension. Sawing the end cuts of the product, you make a successful installation and a
sleek finish. The interior panels can be attached also to the top of the supporting rails, if the width of the bottom rail is at least 45 mm and the distance from centre to centre is 300 mm. We recommend using ART nail batten as a basis.
The installation or construction glue (depending on the installation surface or the glue, the consumption is approx. 80-300 ml / m2). Glue according to the glue manufacturer’s instructions. Make a continuous stripe of glue to the both long sides of the panel and spots of glue to the middle of the panel. Spread glue on the groove as well, which will ensure that the tongue and groove joints are glued together. To facilitate the installation, bring the board slightly over the already installed board.
Pull the board backwards until the boards are at the same level, and push in to the tongue and groove joint. Using a spirit level the panels can be installed straight. Installing the first panel straight is important to make the installation progress correctly.

Tongued and grooved wall panels can also be attached with a staple gun. The distance between the staples should be approx. 100 mm. Secure the fastening by gluing the panel according to the instructions. A pneumatic staple gun is recommended for the installation of the interior panels. Use at least a 22 mm long, 11 mm wide and 1,6 mm thick staples. The staple is shot diagonally to the lower intruding tongue of the female groove. To make the installation of the panels possible, the staples must remain on the same level with the groove. The staple must not sink deep inside the tongue, as then the panel is not properly attached.
Leave a minimum expansion room of 12 mm between the interior panels and the wall or some other surface limited to the panel. If the length or the width of the face is over 6 metres, add 2 mm of the expansion space for each extra metre. The seam is covered by cornices, baseboards and fold moldings.

FINISHING
The wall sockets can be be raised to the same level with the wall surface with a heightening ring. The edges can be finished with suitable wooden, MDF or plastic battens. Maler Oy shall replace a faulty product with a new equivalent product or up to the price of the defective product, Maler Oy is not responsible for indirect costs.

ART Decor Panel maintenance instructions

Remove dirt and dust with a dry or slightly damp cloth, but avoid rubbing. If you want to clean your wall more carefully, wipe it with a slightly damp wiper.
As a detergent, use a gentle universal cleaner (pH 6-8) according to the instructions. To clean your wall, always use as little water as possible.

 

ART mounting video


in englisheesti keelesen françaisрусский

 

art-palstapohja-en